Perle-systems 833IS Manual de usuario Pagina 263
- Pagina / 340
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Appendix 2: AT Command Set
Perle 833IS User Guide 247
X0 Disables monitoring of busy tones unless forced otherwise by country
requirements; send only OK, CONNECT, RING, NO CARRIER,
ERROR, and NO ANSWER result codes. Blind dialing is enabled/
disabled by country parameters. If busy tone detection is enforced and
busy tone is detected, NO CARRIER will be reported. If dial tone
detection is enforced or selected and dial tone is not detected, NO
CARRIER will be reported instead of NO DIAL TONE.
X1 Disables monitoring of busy tones unless forced otherwise by country
requirements; send only OK, CONNECT, RING, NO CARRIER,
ERROR, NO ANSWER, and CONNECT XXXX (XXXX = rate). Blind
dialing enabled/disabled by country parameters. If busy tone detection is
enforced and busy tone is detected, NO CARRIER will be reported
instead of BUSY. If dial tone detection is enforced or selected and dial
tone is not detected, NO CARRIER will be reported instead of NO DIAL
TONE.
X2 Disables monitoring of busy tones unless forced otherwise by country
requirements; send only OK, CONNECT, RING, NO CARRIER,
ERROR, NO DIALTONE, NO ANSWER, and CONNECT XXXX. If
busy tone detection is enforced and busy tone is detected, NO CARRIER
will be reported instead of BUSY. If dial tone detection is enforced or
selected and dial tone is not detected, NO DIAL TONE will be reported
instead of NO CARRIER.
X3 Enables monitoring of busy tones; send only OK, CONNECT, RING,
NO CARRIER, ERROR, NO ANSWER, and CONNECT XXXX. Blind
dialing is enabled/disabled by country parameters. If dial tone detection is
enforced and dial tone is not detected, NO CARRIER will be reported.
X4 Enables monitoring of busy tones; send all messages.
Result Codes:
OK n = 0 to 4.
ERROR Otherwise.
- 5500116-10 1
- Copyrights 2
- Important Safety Notice 2
- INDUSTRY CANADA REQUIREMENTS 5
- About this Book 7
- What’s in the Guide 10
- Contents 11
- Introduction 17
- Section 1: Installation 21
- 6 Perle 833IS User Guide 22
- About Installation 23
- Setting up the LAN Connection 25
- Configuring the 833IS 25
- Verifying Correct Operation 26
- Chapter 2: Site Preparation 27
- Electrical Requirements 28
- Environmental Requirements 29
- 10 Base-T/ 30
- 100 Base-TX 30
- 10 Base-T Network 31
- 10 Base-T Hub 31
- Category 31
- 3,4,5 UTP 31
- 100BaseTX Network 32
- 100Base-TX Hub Category 5 UTP 32
- Type 1 STP 32
- Perle 833IS User Guide 17 33
- STP (Shielded Twisted Pair) 33
- Telephony Cabling 35
- Unpacking the 833IS 38
- Perle 833IS User Guide 23 39
- Feature Cards 41
- BRIU 4 ISDN BRI U-interface 42
- BRIS 4 ISDN BRI S/T-interface 42
- Assembling the Hardware 43
- Rack Mount 44
- Attaching the LAN Cable 45
- Verifying Connection 53
- About Using the Manager 59
- System Requirements 60
- Connecting to the Server 63
- Tool Bar 67
- Status Bar 67
- Menu Bar 67
- Loading Firmware 74
- 60 Perle 833IS User Guide 76
- Section 2: Configuration 77
- 62 Perle 833IS User Guide 78
- How the 833IS Works 79
- Configuration Overview 83
- Using Configuration Files 84
- Setting the Date and Time 90
- Overview 105
- Configuring the Protocols 107
- Configuring IP Protocol 108
- IP Filter 125
- Configuring IPX 130
- ■ Node Address 135
- Configuring PPP 145
- Using AppleTalk 148
- Using NetBEUI 149
- 134 Perle 833IS User Guide 150
- Overview of the User Database 151
- ■ For centralized billing 161
- Lan To Lan 163
- Standard Profile 171
- 162 Perle 833IS User Guide 178
- About Configuring the Server 179
- Configuring the Server 180
- Dial-Out 182
- Security 185
- Group Settings 198
- Perle 833IS User Guide 195 211
- 196 Perle 833IS User Guide 212
- Section 3: Management 213
- 198 Perle 833IS User Guide 214
- 833IS Manager Statistics 215
- Configuration: 226
- Event Log 234
- 833IS Front Panel 236
- Front Panel Main Screen 239
- Front Panel Main Screen Map 239
- 224 Perle 833IS User Guide 240
- Network control displays 240
- Control Menu Map 241
- 226 Perle 833IS User Guide 242
- Network Status Displays 242
- Status Menu Map 243
- Card Status 244
- Card Status continued 245
- Card Status Menu Map 247
- Network Status Display 248
- Perle 833IS User Guide 233 249
- Factory Default Mode 251
- Factory Default Setup 251
- 236 Perle 833IS User Guide 252
- 238 Perle 833IS User Guide 254
- Factory Default Mode Menu Map 255
- 240 Perle 833IS User Guide 256
- Appendix 2: AT Command Set 257
- AT Commands 264
- 248 Perle 833IS User Guide 264
- 264
- Perle 833IS User Guide 249 265
- 250 Perle 833IS User Guide 266
- Automode disabled 274
- S-Registers 277
- 262 Perle 833IS User Guide 278
- 278
- S-Register Definitions 279
- AT Command Set Summary 282
- Appendix 3: Specifications 287
- LAN Interfaces 288
- ISDN BRI Interface 289
- PerleDSP Modem Interface 290
- Approvals 291
- Protocols Supported 292
- LAN Environments 292
- Dial In Clients Supported 293
- Dial Out 293
- Management 293
- RFCs Supported 294
- Account Request Messages 295
- Access-Accept Messages 296
- Perle 833IS User Guide 281 297
- Accounting Messages 298
- Perle 833IS User Guide 283 299
- '%$945 299
- 284 Perle 833IS User Guide 300
- Overview of 833IS 302
- Command Overview 307
- Monitoring the 833IS 312
- 298 Perle 833IS User Guide 314
- Glossary 315
- Trigger Character 320
- UTP (Unshielded Twisted Pair) 320
- WAN (Wide Area Network) 320
- Numerics 321
- Perle 833IS User Guide 306 322
- Perle 833IS User Guide 307 323
- Perle 833IS User Guide 308 324
- Perle 833IS User Guide 309 325
- Perle 833IS User Guide 310 326
- Perle 833IS User Guide 311 327
- Perle 833IS User Guide 312 328
- Perle 833IS User Guide 313 329
- Perle 833IS User Guide 314 330
- Perle 833IS User Guide 315 331
- Perle 833IS User Guide 316 332
- Perle 833IS User Guide 317 333
- Perle 833IS User Guide 318 334
- Perle 833IS User Guide 319 335
- Perle 833IS User Guide 320 336
- Perle 833IS User Guide 321 337
- Perle 833IS User Guide 322 338
- Perle 833IS User Guide 323 339
- Perle 833IS User Guide 324 340
Relacionado con productos y manuales para Hardware Perle-systems 833IS
Hardware Perle-systems Perle IOLAN DS1 Manual de usuario
(224 paginas)
(224 paginas)
Hardware Perle-systems DS1 Manual de usuario
(122 paginas)
(122 paginas)
Hardware Perle-systems IOLAN SCS Manual de usuario
(408 paginas)
(408 paginas)
Hardware Perle-systems RIO 5500036-17 Manual de usuario
(220 paginas)
(220 paginas)
Hardware Perle-systems C-100-XXXXX Manual de usuario
(19 paginas)
(19 paginas)
Hardware Perle-systems 1700 Manual de usuario
(100 paginas)
(100 paginas)
Hardware Perle-systems 5250 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Perle-systems PERLE P850 Manual de usuario
(102 paginas)
(102 paginas)
Hardware Perle-systems IOLINK-520 Manual de usuario
(110 paginas)
(110 paginas)
Hardware Perle-systems Speed LE 1P Manual de usuario
(61 paginas)
(61 paginas)
Hardware Perle-systems S-110P Manual de usuario
(23 paginas)
(23 paginas)
Hardware Perle-systems IOLAN SDS Manual de usuario
(162 paginas)
(162 paginas)
Hardware Perle-systems P840 Manual de usuario
(58 paginas)
(58 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.083 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales